A Case Study on Bulking Problems in Paper Recycling Effluent Treatment Plant in Malaysia
This study was conducted to investigate the cause of bulking problem at the effluent treatment plant
(ETP) of a paper recycling plant in Malaysia. Hypothetically, the effluent is lacking nutrients and could induce the overpopulation of filamentous bacteria, and further cause the bulking problem during the effluent treatment using activated sludge process. Experiment to simulate treatment operations had been set up at laboratory. The simulation showed that the bulking started to occur after the first cycle of the fed-batch operation with the typical effluent. To make up the lacking of nutrients in the effluent, urea (N) and phosphate (P) were added as supplements with the ratio of BOD : N : P equal to 100 : 1.0 : 0.7. The supplemented effluent was again tested by a simulation study and showed that the bulking problem started to take place after the third cycle of feeding regime. Bulking problem also periodically took place in the actual operation when the same supplemented formula was applied; however the frequency of occurrence was lesser. Therefore, this study has shown that other than the lack of nutrients, there are other factors that could cause bulking problem.
Droste, R.L. (1991). Theory and Practise of Water and Wastewater Treatment. John Wiley & Sons, Inc., USA, 554 p.
Ekama, G.A., Barnard, J.L., Gunthert, F.W., Krebs, P., McCorquodale, J.A., Parker, D.S. and E.J. Wahlberg
(1986). Secondary Settling Tanks: Theory, Modelling, Design and Operation. International Association on Water Quality. London, U.K., 17 p.
LRB (Legal Research Board) (2001). Malaysian: Environmental Quality Acts, 1974, International Law Book Services, Petaling Jaya, Malaysia, 120-126 pp.
Martins, A.M.P., Pagilla, K., Heijnen, J.J. and M.C.M. van Loosdrecht (2004). Filamentous bulking sludge—A critical review. Water Research, 38: 793-817.
Metcalf and Eddy Inc. (1996). Wastewater Engineering – Treatment, Disposal and Reuse. Third Edition. McGraw Hill International Editions. Civil Engineering Series, Singapore, 536-538 pp.
MPPMA (Malaysia Pulp and Paper Manufacturers Association) (2002). Current Scenario and Future Development of the Pulp and Paper Industry in Malaysia— Keynote address by President of MPPMA, The Federation of ASEAN Pulp and Paper Industries, at the Pulp and Paper Seminar 2002, Kuala Lumpur, Malaysia.
Sveriges Ambassad (2004). Paper and Pulp Industry in Malaysia: A Fact Pack from the Embassy of Sweden in Malaysia, Office of Embassy of Sweden, Kuala Lumpur, Malaysia.
Thompson, G., Swain, J., Kay, M. and C.F. Forster (2001). The treatment of pulp and paper mill effluent: A review. Bioresource Technology, 77: 275-286
UNIDO (United Nations Industrial Development Organization) (1993). Handy Manual for Paper and Pulp Industry: Output of a Seminar on Energy Conservation in Paper and Pulp Industry. The Energy Conservation Center(ECC), Japan.